Dong Duan Tai Fu Machinery Co., LTD.

News

Contact us

Dongguan Tai Fu Machinery co., LTD.
TEL:0769-81929376
   0769-81929563
FAX:0769-81929375
Contacts:Mr. Tan 13925508995
Address:Dongguan City Shek Pai town Fulong Yang housing factory area.
The current position: Home News Technical

The operating procedures and maintenance of vertical injection molding machine

  • Source:Dong Duan Tai Fu Machinery Co., LTD. Update time:2016-08-13
  • 1, the preparation work
    1.1, check the machine parts and electric control box are in good condition.
    1.2, check the oil level of hydraulic oil, oil storage is enough, start the motor observation axial plunger valve oil is normal.
    1.3, open the water valve on cooling water.
    2, operation
    2.1, loading mode: push the move mould institutions to highest, plastic mold in a template, unscrew the fixed template, correction and plastic mould on the mould and fixed template. Tighten screw, tighten under the plastic mold die on template, run move mould, check the mold position is correct.
    2.2, cylinder heating: on of the electric switch electrical control box, add plastic inside the cylinder, sufficient heat melt plastics.
    2.3, injection operation: through the electromagnetic valve of 8 make move mould institutions rise and plastic mold closing, through to the electromagnetic valve 6 to injection molding press plunger into the cylinder. After the injection through the electromagnetic valve 6 injection plunger withdrew from the cylinder pressure, through the electromagnetic valve of 8 institutions declines, the moving mould, plastic mould can be open mold release.
    3, maintenance and maintenance
    3.1, check the storage condition of the hydraulic oil is enough, when should be added in time, often should clean oil.
    3.2 regular lubrication, lubrication points according to the regulation, regular cleaning filter. Keep the machine around clean, must not make dirt into the tank.
    After 3.3, the use of the machine should be on the dirt rub-up, smooth surfaces should be greased
    3.4 and electrical parts, regular check, remove dirt, oil, dust, keep the electrical contact clean, often clear the dirt and dust on the joint.

btop.php网站首页 | About Us | products | News | Resources | Service | video | Contact Us

Copyright © 2016-2019 all rights reserved Dongguan Tai Fu Machinery co., LTD.
TEL:0769-81929376 81929563 81379398 Address:Dongguan City Shek Pai town Fulong Yang housing factory area

友情链接:凤凰娱乐彩票注册  88彩票平台  M5彩票注册  GT彩票官网  状元彩票平台  GT彩票  大无限彩票官网  拉菲彩票平台  永利彩票  幸运彩票  

免责声明: 本站资料及图片来源互联网文章,本网不承担任何由内容信息所引起的争议和法律责任。所有作品版权归原创作者所有,与本站立场无关,如用户分享不慎侵犯了您的权益,请联系我们告知,我们将做删除处理!